M2F1G64CB88A4N / M2F2G64CB8HA4N
1GB: 128M x 64 / 2GB: 256M x 64
Unbuffered DDR3 SDRAM DIMM Preliminary
REV 0.1 18
© NANYA TECHNOLOGY CORP.
NANYA TECHNOLOGY CORP. reserves the right to change Products and Specifications without notice.
Command and Address Timing
Internal READ Command to PRECHARGE Command delay
Delay from start of internal write transaction to internal read
command
Mode Register Set command cycle time
Mode Register Set command update delay
Auto precharge write recovery + precharge time
WR + roundup (tRP/tCK(avg))
Multi-Purpose Register Recovery Time
ACTIVE to ACTIVE command period for 1KB page size
Four activate window for 2KB page size
Command and Address setup time to CK, referenced to Vih(ac)
/ Vil(ac) levels
Command and Address hold time to CK, referenced to Vih(ac) /
Vil(ac) levels
Power-up and RESET calibration time
Normal operation Full calibration time
Normal operation Short calibration time
Exit Reset from CKE HIGH to a valid command
max(5nCK, tRFC(min) +
10ns)
Exit Self Refresh to commands not requiring a locked DLL
max(5nCK, tRFC(min) +
10ns)
Exit Self Refresh to commands requiring a locked DLL
Minimum CKE low width for Self Refresh entry to exit timing
Valid Clock Requirement after Self Refresh Entry (SRE) or
Power-Down Entry (PDE)
Valid Clock Requirement after Self Refresh Exit (SRX) or
Power-Down Exit (PDX) or Reset Exit
Exit Power Down with DLL on to any valid command; Exit
Precharge Power Down with DLL frozen to commands not requiring
a locked DLL
Exit Precharge Power Down with DLL frozen to commands
requiring a locked DLL
Command pass disable delay
Power Down Entry to Exit Timing
Timing of ACT command to Power Down entry
Timing of PRE or PREA command to Power Down entry
Timing of RD/RDA command to Power Down entry
Timing of WR command to Power Down entry (BL8OTF, BL8MRS,
BC4OTF)
Timing of WRA command to Power Down entry (BL8OTF,
BL8MRS, BC4OTF)
Timing of WR command to Power Down entry (BC4MRS)
Timing of WRA command to Power Down entry (BC4MRS)
Timing of REF command to Power down entry
Timing of MRS command to Power Down entry
Comments to this Manuals